Single PinPoint Duo add-on

 Buy For My Pro Shop
 
 

Overview

Add one more PinPoint Duo to your system to get rev rate and extra shot detail. A full rev-rate system uses 4 units, and this one is placed at 55 feet.

How to Set It Up

  1. Charge the device first: plug the USB cable into one of its two USB ports. It takes 2 to 3 minutes to boot, and the display shows the battery percentage.
  2. Spin the mini flat tripod onto the device (do not over-tighten) and set it over the lane's big gutter cap with one leg pointing toward the lane. Use the small built-in level so it sits level with the lane.
  3. Keep it far enough from the lane that it sees the ball, not the lane, and out of reach of a gutter ball.
  4. Scan the QR code on the device (or open the PinPoint DUO web page) or use the Ten Pin Doctors app, then press Connect and pair with the device over Bluetooth.
  5. Calibrate: place a ball on board 5 in front of the sensor and press Calibrate.
  6. Pick a target board for each device, press Ready to Bowl, and start throwing.

What's Included & Specs

  • 1 PinPoint Duo unit
  • Mini flat tripod for the gutter cap
  • Battery life of around 8 to 10 hours; charges over USB

FAQs

Does it work at any bowling center?

Each unit sits beside the lane over the big gutter cap. It can't sit over a small gutter cap.

Do I need the app?

You can use the PinPoint DUO web page from the QR code on the device or the Ten Pin Doctors app for iOS and Android. On an iPhone, use the app or the Bluefy browser.

How long does the battery last?

Around 8 to 10 hours per charge.

How many units do I need for rev rate?

Four. With fewer than four reporting you still get line, speed and shape, and the app holds back the rev number rather than guessing at one.