PinPoint Duo + Revs system

 Buy For My Pro Shop
 
 

Overview

PinPoint Duo with Revs is a 4-unit set that captures the whole shot, including rev rate. Each unit sits beside the lane and reports the exact board your ball crossed and the instant it crossed it. Four fixed points on every shot are enough to rebuild the whole shot, with no camera and nothing taped to the ball.

Every Shot Gives You

  • Rev rate and axis rotation, solved from the measured path
  • Release speed, speed down lane, and how much speed the lane took out
  • Launch angle and lay-down board
  • Board and timestamp at every unit
  • Breakpoint board and how far down the lane it was
  • Entry board and entry angle
  • Every shot saved, so you can scroll back through a session

Why Four Units

Boards alone can't separate rev rate from axis rotation: a 350 rpm release at 45 degrees and a 500 rpm release at 14 degrees cross the same board at 40 feet. The difference shows up in the back end. Across the 250 to 500 rpm range, the board crossed at 25 feet moves about 1.4 boards, but the board crossed at 55 feet moves about 17. The two near units fix your line and release speed, and the two far units are solved for rev rate and rotation.

How to Set It Up

  1. Charge the device first: plug the USB cable into one of its two USB ports. It takes 2 to 3 minutes to boot, and the display shows the battery percentage.
  2. Spin the mini flat tripod onto the device (do not over-tighten) and set it over the lane's big gutter cap with one leg pointing toward the lane. Use the small built-in level so it sits level with the lane.
  3. Keep it far enough from the lane that it sees the ball, not the lane, and out of reach of a gutter ball.
  4. Scan the QR code on the device (or open the PinPoint DUO web page) or use the Ten Pin Doctors app, then press Connect and pair with the device over Bluetooth.
  5. Calibrate: place a ball on board 5 in front of the sensor and press Calibrate.
  6. Pick a target board for each device, press Ready to Bowl, and start throwing.

FAQs

Does it work at any bowling center?

Each unit sits beside the lane over the big gutter cap. It can't sit over a small gutter cap.

Do I need the app?

You can use the PinPoint DUO web page from the QR code on the device or the Ten Pin Doctors app for iOS and Android. On an iPhone, use the app or the Bluefy browser.

How long does the battery last?

Around 8 to 10 hours per charge.

How many units do I need for rev rate?

Four. With fewer than four reporting you still get line, speed and shape, and the app holds back the rev number rather than guessing at one.